pias wing-tip self-drilling screw, countersunk milling head with AW recess
SCR-DBIT-WNG-CS-CUTHD-AW40-(RUS)-8X100
Art.-no. 0219008100
EAN 4038898074106
Register now and access more than 125,000 products
- Steel, Ruspert-coated (grey)
- Cr(6)-free corrosion protection, approx. 500 h with no base metal corrosion (salt spray test as per DIN EN ISO 9227-NSS)
- AW recess system for better torque transmission, a longer service life and optimal centring
- Wing-tip pias screws must be appropriately tested for usability for each application.
- Only install using application tools with a depth stop and claw coupling.
- The maximum fixture length is calculated as follows: Wood thickness + substructure thickness lU = max. fixture length
- Self-drilling screws must be installed with a suitable drill/driver (e.g. cordless drill/driver with depth stop)
- The use of impact drivers is not permitted
- Self-drilling screws must be screwed in perpendicular to the surface of the component
Zinc plated self-drilling screws must only be used in locations where permanently damp conditions are not expected - condensation is not considered a permanently damp condition (corrosivity category ≤ C2 in accordance with DIN EN ISO 12944-2). For fasteners with technical approval, the approval, and in particular Part 2 "Special regulations", must always be observed.
Datasheets(X)
For use with hard and soft woods
- Force feeding of the screw is prevented by the wings drilling out the wood
- The core hole is drilled into the substructure. The wings break off upon contact with the metal
- The first few turns of the screw cut the thread, the remainder of the screw then screws into the thread
 | |
Nominal diameter (d) | 8 mm |
Length (l) | 100 mm |
Head diameter (dk) | 15 mm |
Head height (k1) | 5.4 mm |
Drill tip length (lp) | 18 mm |
Other standard | Company standard |
Material | Steel |
Surface | Flake zinc grey |
Head type | Countersunk milling head |
Internal drive | AW40 |
Thread type | Metric thread |
Min. recommended substructure thickness | 3 mm |
Max. material thickness to be drilled through (metal) (lU) | 12 mm |
Max. attachment thickness (lB) | 68 mm |
Min./max. recommended installation speed (idling) | 600-1200 rpm |
RoHS-compliant | Yes |
Last viewed
Pneumatic cleaning gun TOP Gun
Two-hand angle grinder EWS 24-230-T
ORSY BULL basic set of partition elements for customised partitioning of ORSY BULL top loader boxes
Insert nut WN 385, blue passivated zinc plated steel (A2K)
Type 80 staples
Grid side wall for boltless rack
Thread mandrel for PEG 312
SHARK Hammer hammer-in fixing TYPE SK
Pro mechanic's glove
Hexagon bolt with shank ISO 4014, steel 10.9, plain